How to Use SP Flash Tool Tutorial 'Tutorial'

SP Flash Tool is a Windows-based software that helps create a bridge or connection between an Android smartphone and a computer via USB cable. This tutorial will guide users through flashing stock firmware (ROM) on devices powered by Spreadtrum/Unisota Chipset using the SPD Research Tool.

Before proceeding, please note that flashing or installing stock firmware using SP Flash Boot may wipe out personal data from your device's internal storage. Therefore, it is highly recommended to backup all important files and information before attempting this process.

System Requirements:

- Windows operating system (XP/Vista/7/8/10)

- SPD Research Tool installed on computer

- USB cable

Step 1: Connect Your Device via USB Cable

1. First, connect your Android device to the computer using a standard USB data-cable.

2. Make sure that both devices are turned off.

Step 2: Install and Launch SP Flash Tool

1. Download and install the latest version of SPD Research Tool from an official website or reputable source onto your Windows PC if not already installed.

2. Double-click on the installation file (usually .exe) to start the setup process, following all instructions until it completes successfully.

Step 3: Boot Your Device into Recovery Mode

1. Power off your device completely by pressing and holding down both power buttons for a few seconds until you feel vibration or see the LED light up.

2. Press Volume Down + Power button simultaneously while keeping volume UP pressed until you enter recovery mode (usually indicated by an exclamation mark on screen).

Step 4: Flash Stock Firmware Using SP Flash Tool

1. Open SPD Research Tool on your computer and connect it to your device via USB cable again if not already connected.

2. In the main interface, click 'Download' or 'Flash/Recovery' depending upon what option is available based on version used.

Step 5: Select Stock Firmware File (.zip/.tar)

1. Navigate through local storage (e.g., C:\Users\Username) and select the .zip or .tar file containing stock firmware for your specific device model.

2. Make sure that 'Firmware Upgrade' option is selected before proceeding further down below.

Step 6: Flash Stock Firmware

1. Click 'Start to Recovery Mode' or 'Update/Flash' depending on version used once you've selected the correct file and options are set properly across all fields in SPD Research Tool's main window.

2. Wait patiently for flashing process to complete, which may take several minutes based on size of firmware being flashed onto device internal storage.

Step 7: Reboot Your Device

1. Once completed successfully, your device will automatically reboot into normal operating mode once finished booting up completely after successful flashing procedure has been fully executed without any errors encountered throughout entire process chain from initial connection through final system startup post-upgrade completion milestone reached.

Congratulations! You have now learned how to use SP Flash Tool to flash stock firmware on devices powered by Spreadtrum/Unisoc Chipset using the SPD Research Tool. Remember always backup your data before attempting such operations, as they may result in permanent loss of personal information if not performed correctly.

Tutorial sp flash tool